If the asphalt around a grate keeps sinking, patching the asphalt won’t stop it. The problem is usually the top of the catch basin itself. A catch basin is the box under the grate that collects surface water and sends it into the storm pipe, and the part that fails is the top: the frame, the grate, and the rings or mortar the frame sits on. When that goes, the asphalt around it goes with it.
Signs a catch basin needs repair
- Sinking around the grate. A dish-shaped dip forms in the asphalt around the basin and gets deeper each season.
- Ponding near the basin. Water collects around the grate instead of going in, because the grate is now higher or lower than the asphalt around it.
- A broken or rocking frame. The cast iron frame is cracked, loose or tipped, and the grate rattles or shifts when a car drives over it.
- Cracks circling the basin in the asphalt, a sign the ground under it is moving.
- Voids and holes next to the frame where you can see down into the gap, or where the asphalt has broken away.
Each of these is a trip hazard and a vehicle hazard as well as a drainage problem. A sunken basin in a drive aisle or near a walkway belongs at the top of any repair list, and in winter the dip fills with water and freezes. Cone it off until it’s fixed.
What causes it
Freeze-thaw
Water gets into gaps around the frame, freezes, expands and pushes the frame and the asphalt apart. By spring the gaps are larger and let more water in. Over a few winters, the top of the basin loosens and the asphalt around it settles.
Failed mortar or adjustment rings
The frame sits on a stack of adjustment rings or courses set in mortar, used to bring it to the right height. When the mortar cracks or the rings break, the frame drops and water leaks out of the basin into the surrounding base. That water washes away fine material and leaves a void under the asphalt, which is why the dip keeps coming back after every patch.
Heavy traffic
Garbage trucks, delivery trucks and plows hit catch basins hard, especially basins placed in drive aisles or turning areas. Repeated impact breaks the frame loose from its seat.
Original installation
Some basins were never set at the right height or were surrounded by poorly compacted fill. These tend to show problems early and keep showing them.
How a catch basin is repaired
- Cut out the asphalt around the basin in a clean square, wide enough to reach sound material.
- Remove the frame and grate and break out the damaged rings and mortar.
- Rebuild the top of the basin with new adjustment rings or courses set in mortar, to the height the finished surface needs.
- Reset the frame and grate, replacing them if the frame is cracked or the grate is damaged.
- Rebuild the base around the basin with compacted granular material, filling any voids left by washout.
- Repave around it with hot-mix asphalt, compacted tight to the frame and shaped so water runs toward the grate.
The aim is a basin that sits slightly below the surrounding asphalt, so water drops in instead of running around it. On a lot with several problem basins, the quote prices each one by location, so you can decide which to do first.
When it’s a sewer or blockage problem
Some catch basin problems sit below what anyone can see from the top. If water rises in the basin and doesn’t drain, if the basin is full of sediment, or if a sinkhole opens near the basin but away from the frame, the cause may be a blocked or broken storm pipe. That needs a drain or sewer contractor who can vacuum the basin, run a camera through the pipe and repair the line.
If you see those signs, get the line checked before the top is rebuilt. Rebuilding the top of a basin with a broken pipe below it only moves the problem. On commercial jobs we coordinate with the drain contractor, so their work and ours happen in the right order.
Doing basins with other work
Catch basins are best repaired in the same visit as the asphalt around them:
- With spring repairs. A repair list often includes one or two basins alongside potholes and crack filling, sorted by the same priorities as other parking lot repairs.
- With resurfacing or a rebuild. Every basin is adjusted to the new finished grade, so none sits proud or sunk; the parking lot paving page explains how grading and basins work together.
- Every year. Property managers can add basin checks to a yearly maintenance program.
To get basins priced, send a photo of each one with something in the frame for scale, and mark where each sits on a site plan or aerial photo. Use our contact page.
