How the numbers are worked out
The calculator multiplies your driveway's area by our 2026 range of $3.50 to $7.00 per square foot. Driveways under 920 square feet are never shown below our $3,200 minimum. Results are rounded to the nearest $10. Parking lots use our range of $3.50 to $5.00 per square foot.
These are the same figures as our driveway cost guide and parking lot cost guide, so the calculator and the guides always agree.
How to measure your driveway
- Width. Measure across the driveway in feet. If it's wider at the street than at the garage, measure both ends and use the number halfway between.
- Length. Measure from the garage door to the edge of the road.
- Anything extra. For a side pad, a turnaround or a flared end, multiply its width by its length and put the result in the extra area box.
A tape measure is best, but pacing it out is close enough for a ballpark. We measure it properly on the site visit.
What decides where you land in the range
The calculator knows the size and nothing else. Whether your driveway sits near $3.50 or near $7.00 comes down to the site: how much old asphalt has to come out, the ground under it, how trucks get in, and where the water has to go. The driveway cost guide takes each of those in turn, with worked examples.
What the calculator can't see
It can't see the ground under the old asphalt, a base that was never thick enough, or water that runs the wrong way. Some of that shows on a site visit, in how the old surface has cracked and sunk and where water sits. The price that counts is the written estimate after we've measured, and it costs you nothing.